Yet the yellow exclamation mark still there. To answer your question on the driver - I did try to update driver, but after launching the update and some 'munching' windows says "you have the latest version of the driver installed". The driver I use is Intel(R) Imaging Signal Processor 2400. HP initially told me I needed to update the driver I had and they even installed the new driver but that still did not work even following them RESTART the system. I have no idea what driver is contain in SP52437. When I tried the automatic option I got the driver HP installed but that did not work so I tried the local option and I installed the driver I mention below. Try both the internet update and the search the computer options. It may be the driver you have is not correct as you are getting a marker beside your imagining devices. I notice you tried Restart after initial startup and the camera still did not work, now as I said that did work for me. disabled Fast Start up (right?), but that didn't help - webcam is still not working (Skype don't see it). In my control panel I do see Imaging devices and a driver 'USB2.0 UVC 1M HD WebCam' with a yellow exclamation mark, but when I try to update the driver the system fails to find a newer version and the exclamation mark remains.Īnyway, restarting straight after start up should have had the same effect, i.e. Itried to re-nstall the same driver (SP52437) but during installation it said "Setup has determined that your configuration does not support any of the included products" The next day after win 10 update the webcam stopped working again. I then downloaded and installed the webcam driver (HP Webcam Software (International), SP52437) from HP website and hooray - the webcam started to work (skype could see it) and I could take images. Then I looked in the device manager - there was no imaging devices at all. Pre-history: I upgraded from win 7 to win 10, installed skype but found skype can't see my webcam. In both cases you have to track down that piece of software somehow. So either you are missing some LabVIEW driver to access the proprietary USB driver from Thorlabs or they somehow installed on the old computer a driver for the camera that turned the proprietary camera protocol into a standard Windows Webcam device. Again on NIMAX, the webcam appears but nothing for the Thorlabs camera. The DCC1545M camera appears but only under the USB listing. In Windows Device Manager, the only "cameras" that appear are built-in webcams. But I can't get Labview/NI Max to recognize it all. I have the native Thorlabs drivers installed and their native app works. The core issue is that Labview is unable to see the USB 2.0 CMOS camera (Thorlabs DCC1545M) that I'm using. I'm trying to debug some old Labview code and get it running on a modern system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |